My ANI server was locking up with OutOfMemory Exceptions and subsequent NullPointer Exceptions and I found that AVPOLLER was taking almost 1GByte of memory on the box (after about 1 month without a reboot/CW2000 restart). Are there any known issues with AVPOLLER that would cause it to take so much memory, or should I restart the service once and a while?
Also, I am getting a lot of WARNING messages in my ANI log indicating that index 4096 does not reference a valid VLAN and was wondering that since there are so many of these messages, if there is a way of turning them down? Any help would be appreciated...
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...