Has anyone had any experience, good, bad or indifferent with bringing a PRI in on a 2 port PRI WIC card on a 3640 and sending the call immedialty out the 2nd port? I am doing a slow migration to CM but need to continue to bring certain DIDs in and send them over the 2nd PRI port to a legacy phone system. I am using a 3640 running 12.(8)T4. I am going to go live with it later this week. On a previous post one of the Cisco guys mentioned the possibility of some bugs or wierd behavior when hairpinning a call like this. Wanted to see what I should expect. Anyone?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...