Hi everyone, I have a small problem with 2 of my 3500XL. It started with a port who was working in autosensing mode and the next day, it stopped working. So I tried all the settings and the only way I was able to use the port was to set it in half 10. Some days later, all the ports stopped working except in half 10. Does anybody have a solution ???
Hi Milan, on my first switch, it was a 3COM SuperStack 3 hub and on my second switch, it was a HP printer with HP jetdirect 610 card. They worked fine for almost half a year. It began with the port where these two devices were connected and 2-3 weeks later, it was the entire switch (all 24 ports) that worked only in half 10. On the other ports, it's workstations and other printers that are connected.
I read the PDF you sent, it did answer a lot of questions I had in mind but I don't see how it can help me on my problem...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.