Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Hardware Module Problem

When I do a 'show module' command I see that 3 of the modules are in a pwrdwn status and 2 are in an 'ok' status. I tried doing a 'hw-module module 7 reset'' command to try and bring module 7 back to an ok status. I say yes to the confirm and I get the response module 7 is operationally off, fabric required'. I then try doing the 'fabric required command but this does not restore the module to an ok status. What can I do.

1 REPLY
Silver

Re: Hardware Module Problem

try a 'sh test mod#' This will show if the module is faulty

222
Views
0
Helpful
1
Replies