Thanks for the info, the first config shows just connections to analogue devices. Would I be able to have a single BRI interface ie BRI2/0 accepting analogue call and ISDN calls and also send analogue and ISDN calls, or do I need to specify a BRI seperately and if so, if I have BRI2/0 to BRI2/3 should I put the "isdn incoming-voice modem" on the last interfaces eg BRI2/2 and BRI2/3 and leave the first 2 interfaces to handle ISDN traffic
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...