We have a 1720 with serial port and one ethernet card. Used to provide frame relay internet access to internal networks. 192.168.0.0. I Would like to provide routing to additional subnets ie 192.168.1.0 Can anyone help with configuring a 1720 router to provide addtional ip address ranges to the existing range for the serial port eg existing address 126.96.36.199 to 155 (255.255.255.252)New range 188.8.131.52 - 143 . I Would like to use the additional IP addresses to connect Qty 2 PIX501 firewall routers to connect the new subnets and provide individual and seperate internal networks
Youll just have to modify your ip route lines slightly for the serial interface change. Keep in mind that if you are adding two PIX firewalls, using one Ethernet interface for both will be very self defeating.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...