Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Help in switch port analysis

Greetings!

I am new to Switch monitoring. I have setup span in a 2900 cisco switch. The actual command i used is: "set span 2/1 3/25". But it is not giving the full traffic. Am i missing out anything?

Thanks and Regards,

Saifullah

1 REPLY
VIP Purple

Re: Help in switch port analysis

Hello,

try this:

Switch> (enable) set span 2/1 3/25 both

Switch> (enable) set span enable

Although 'both' is the default when nothing is specified, check if explicitly stating it gives your more traffic to monitor.

Regards,

GP

80
Views
0
Helpful
1
Replies
CreatePlease to create content