I have a 2600 router, and I was running 12.2(15)T17. Today, I just tried 12.3(24), and found it did not support OSPFv3, so I want to go back to 12.2(15)T17. But I cannot copy the image into flash.
When I originally installed 12.2(15)T17, I had to use a special technique that I adapted from a 1700 series document I had read. Normally, there is not enough space in flash to install the image. But if you erase the flash first with a special hidden option, you can. What the option does is to sacrifice the squeeze space, leaving just enough space for the image. It is something like /nosqueezespace, but it doesn't appear in the command help.
Can anyone remember what the option is? I feel especially foolish because I even remember posting something about it a couple of years back, but I cannot find it.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...