Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Help me for the router suffered by the Virus.

Experts

One of our client (a Little Service Provider) use a 7204vxr as there

Internet Access Router, they use NAT for their clients, but recently,

the router is always suffered by High CPU Utilization, when they use the

command "show ip nat trans" , a big amount of connection with the same

src & dst ip address are found, maybe caused by RedCode or the Virus

similar, when use "clear ip nat trans *" the CPU Utilization dived down ,

My problem is how to resolve it efficiently?

Thanks in advance

Bryan

2 REPLIES
New Member

Re: Help me for the router suffered by the Virus.

Bryan

The best idea is probably to apply an ACL on the LAN interface refusing traffic using that dst and src - just until you can clean up the infected machine.. This will at least keep it from using up CPU.. Better still: take that machine offline :)

-Matt

New Member

Re: Help me for the router suffered by the Virus.

You may want to check the problem against a recent bug release on the 7200 VXR routers:

The link:

Title: Field Notice: Mueslix Halts on Cisco 7200 Series Routers

URL: http://www.cisco.com/warp/customer/770/fn18950.shtml

Posted: April 25, 2002

Summary: On a Cisco 7200 Router, when the mueslix serial port

adapters are used with a high bandwith port adapter (like ATM)

in the same PCI bus, the serial interface may stop functioning

when NVRAM is accessed. This can occur when the interface traffic

rates reach approximately 50 percent on the serial and high

bandwidth interfaces.

Hope the above information will be able to assist you.

C

99
Views
0
Helpful
2
Replies
CreatePlease to create content