Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k

Help on FEC

hi

i m trying to enable port channel but its giving error

Switch(config)#int port-channel 1

^

% Invalid input detected at '^' marker.

Switch(config)#

this is the output of my sh ver..of the switch.

Switch#sh ver

Cisco Internetwork Operating System Software

IOS (tm) C2900XL Software (C2900XL-C3H2S-M), Version 12.0(5)XU, RELEASE SOFTWARE

(fc1)

Copyright (c) 1986-2000 by cisco Systems, Inc.

Compiled Mon 03-Apr-00 16:37 by swati

Image text-base: 0x00003000, data-base: 0x00301398

ROM: Bootstrap program is C2900XL boot loader

Switch uptime is 11 minutes

System returned to ROM by power-on

System image file is "flash:c2900XL-c3h2s-mz-120.5-XU.bin"

is this ios ver supports FEC ???

pls help on this

regds

prem

2 REPLIES
New Member

Re: Help on FEC

Hi

You cannot use the int port-channel command. Infact you have to use the port-group command.

Agnelo

Re: Help on FEC

hi agnelo

thks for replyin...

i m getting the option for port-channel when i give a command like this

TestSwitch(config)#inter ?

FastEthernet FastEthernet IEEE 802.3

Multilink Multilink-group interface

Port-channel Ethernet Channel of interfaces

VLAN Switch VLAN Virtual Interface

Virtual-TokenRing Virtual TokenRing

but i dont know why i m not able to enable them.i tried port-group under each interface where i can do the config for port-group becoz if i give portgroup in global mode its not taking it ...

regds

prem

222
Views
0
Helpful
2
Replies
CreatePlease to create content