Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Help on module selection

I have a line that is described as :-

Digital-2 Mbit/G.703 RJ45(120ohm balanced) to RJ45(120 ohm Balanced).

It is an E1 circuit.

I wish to put a 2600 router at each end.

What module do I require for this?

Thanks for any assistance,

Charlie

2 REPLIES
New Member

Re: Help on module selection

Charlie,

You might need 1 or 2 port VWIC-MFT-E1. Check this URL for more detail:

http://www.cisco.com/warp/public/788/products/vwicmf_e1.html

Regards,

Bessie

Cisco Employee

Re: Help on module selection

If it's just for data, then the following modules will do what you want:

NM-1FE1CE1B, 1 FastEthernet, 1 Channelized E1

NM-1FE2CE1B, 1 FastEthernet, 2 Channelized E1

NM-1CE1B, 1 Channelized E1

NM-2CE1B, 2 Channelized E1

These modules will take up an entire slot.

The VWIC mentioned above can do voice and data on the same module and must be in an NM-HDV to terminate voice calls.

Regards,

Clay

88
Views
0
Helpful
2
Replies
CreatePlease to create content