HELP PLEASE!!!!SWITCH CLUSTERING PROBLEM OR SOMETHING????
ok here is the deal....I am trying to add a 2950 cisco switch to a cluster of 2 other switches thru a gbic interface...I have the IP assigned to the vlan1...it seems everything is hooked up correctly and I check config files against the other two switches and everything seems the same...does anyone know what the problem might be????I cannot for the life of me figure out what else to do to be able to see the switch on the network....any help is greatly appreciated...thanks
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...