cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
383
Views
0
Helpful
2
Replies

help required in configuring telnet

sivakondalarao
Level 1
Level 1

Hi,

We have two PIX 515E firewalls working in HA mode.

I wanted to configure telnet access to firewalls from outside interface.

PIX version is 6.3(5)

I kept PC outside to outside interfaces.

PIX outside IP is 10.10.200.3, inside IP is 10.10.202.5 corresponding virtual IPs are 10.10.200.2 and 10.10.202.7

I have tried following configurations:

pix(config)#telnet 0 0 inside

pix(config)#telnet 0 0 outside

pix(config)#telnet 10.10.200.0 255.255.255.0 outside

pix(config)#telnet 10.10.202.0 255.255.255.0 inside

pix(config)#telnet 10.10.200.200 255.255.255.255 outside

I am able to telnet from internal interface side using inside ip address.

But from outside test pc with IP 10.10.200.200 I am not able to telnet to PIX.

I enabled logging console 5.

when I tried to telnet to outside virtual IP it is not showing any traffic to firewall.

If I try to outside interface I am able to see the traffic like

packets received from source 10.10.200.200 to 10.10.200.3

any help in this configuration. I wanted to telnet firewall from test pc.

Regards

SKRAO

1 Accepted Solution

Accepted Solutions

m.sir
Level 7
Level 7

HI SKRAO,

from security reasons is not possible to telnet to outside interface there is no way how to permit this you need you ssh instead of telnet

here is more info about setting ssh

http://www.ciscopress.com/articles/article.asp?p=25342&seqNum=3&rl=1

M.

Hope that helps rate if it does

View solution in original post

2 Replies 2

m.sir
Level 7
Level 7

HI SKRAO,

from security reasons is not possible to telnet to outside interface there is no way how to permit this you need you ssh instead of telnet

here is more info about setting ssh

http://www.ciscopress.com/articles/article.asp?p=25342&seqNum=3&rl=1

M.

Hope that helps rate if it does

Thanks for your reply.

Regards

SKRAO

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco