Im running a cisco WS-C3508G-XL-EN with software 12.0(5.4)WC(1) and 4 WS-G5482 1000Base-T GBICs connected to and 1 Intel Pro 1000-T (Driver version 2.84.284.0) network Card and 3 3Com 3c996-T Gigabit Copper Cards (Driver Version 1.29).
All the PCs are running Windows 2000 pro or server.
The built in diag software that comes with the drivers reports that its connected at gigabit speed and there are no dropped or bad packets.
The ports are configured for auto negotiation, full duplex and asymmetric flow control.
But if I connect to the console port on the back of the 3508 it reports 2d23b: %LINK-3-UPDOWN: Interface GigabitEthernet0/1, Changed state to up.
It then changes state to down, this happens for all connected ports.
As a result the throughput on the gigabit ports is less than on a 100 port.
Can anyone give me any idea what I can do to keep the ports up?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...