Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Help, span on 6509

Hi, i need span a port on a cat 6509, i have two vlans, and when i set the port to span, the port gets down, and it doesn't work...

The switch has a crossover cable between 2 vlans (yes, i know, but i didn't do it, and its working) and i cannot touch that... someone have some idea?

o m a r g 1

pd: i'm sorry about my english, but i'm from Argentina...

2 REPLIES
New Member

Re: Help, span on 6509

Are you setting this port as the source or destination?

Is the sniffer connected to the destination port?

Is there any traffic going over the source port?

What do you mean by "goes down"?

New Member

Re: Help, span on 6509

I solve de problem, the problem was a syntax prolblem...

i was not putting the inpkts parameter... i did that, and it work!

Thanks

256
Views
0
Helpful
2
Replies