I am trying to get a 3rd party software vendor able to PCAnywhere into a server Behind NAT. The DSL router is a cisco 678 (el cheapo from qwest)with a dynamically asigned public IP. I can find the IP out at any given time on Qwest's side. How can I get them connected to a server behind NAT with a private address of 10.x.x.x.. Since there is no static public IP I can't set up a temporary one to one NAT.
You need a static IP my friend. It's possible to set up without, and you can always find out your dynamically assigned address, but you can't tell when that address will expire. Having a vendor connect to an ip address that may change during a session...You may want to look at other options.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...