Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Help w/ Splitting Upstreams (load balancing) on UBR7200

Good day, we have an issue w/ our UBR's. Some of our nodes are oversaturated w/ 300-400 users. We would like to be able to split the node between 2 upstreams. Haven't found too much info on this, although one document said it could be done, it didn't say how. To my understanding we can assign different frequencies to each upstream and split the node, and the Cable modems will pick up different UDP's and somewhat load balance... ideas?

1 REPLY

Re: Help w/ Splitting Upstreams (load balancing) on UBR7200

Often times complex configuration issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

104
Views
0
Helpful
1
Replies
CreatePlease to create content