My company has provided me a 827 router with a direct link to the main campus network. The problem is that I have a network running at my house that utilizes a DHCP server. The Hospital would like me to DHCP my devices from them, but I want to keep mine separate and just use my assigned IP to connect. I think that NAT is the answer, but I am not familiar enough to setup. Since it is my home, the IS guys are not very helpful in helping me figure out a solution.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...