Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Help with Netconfig

I am trying to use netconfig to update my running-config on a 2620 router. I would like to call the file from tftp server. If I enter the command below into the router, it will copy my changes int the router, but I must hit return once after the file was entered to verify where to write the file.

copy tftp://1.1.1.1/tftpboot/configfile run

When I create a template in netconfig and put in the same command as above, I recieve the following error message:

Update Result: Failed

FAILURE

-CLI OUTPUT-

FAILURE

Any ideas on how the get ciscoworks to call the file from my tftp server ??

Thanks in advance.

Ben

1 REPLY
Silver

Re: Help with Netconfig

Did you check the connectivity to the tftp server? If it is fine, did you double check the filename of the configuration file? If both of these are fine, then I guess, you should be missing some of the NetConfig Requirements given in the document below:

NetConfig Requirements

http://www.cisco.com/en/US/products/sw/cscowork/ps2073/products_tech_note09186a00800a6974.shtml#requirements

Or may be, you could use the Config Editor for this purpose.

105
Views
0
Helpful
1
Replies
CreatePlease to create content