Re: HI,how long time to turn half to full on cisco 2950 ?
If you have spanning tree enabled and portfast disabled it will take approx 50 seconds to change from half to full duplex assuming that you lose carrier, this 50 seconds is due to spanning tree blocking / listening / learning / forward cycle ( 2 x forwarding delay + max age).
If portfast is enabled the change should be nearly instant as this transitions the port straight to forwarding bypassing the blocking / listening / learning stages.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...