Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

High-Availability Redundancy 6509 with IPX and DecNet

Is it possible to configure IPX and DecNet in a 6509 with High-Availability Redundancy. The ALT command does not seem to work.

Thank you,

  • Other Network Infrastructure Subjects
1 REPLY
New Member

Re: High-Availability Redundancy 6509 with IPX and DecNet

IPX is supposed to be supported in High-Availability mode however DecNet is not.

See the below section I copied from

http://www.cisco.com/en/US/products/hw/switches/ps708/products_white_paper09186a0080088874.shtml

-----------------------------------------------------

MSFC-Sup-15 (config-if)# standby 10 priority 100 alt standby 10 priority 50

The command syntax does not change. The portion of the command listed before the alt keyword applies to the MSFC in slot 1 and the portion of the command listed after the alt keyword applies to the MSFC in slot 2. The config-sync feature is only supported for general IP or IPX configurations; configuration parameters for Appletalk, DECnet, etc. do not have corresponding alt keyword options.

---------------------------------------------------

Hope this helps

140
Views
0
Helpful
1
Replies