Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

high cpu load on cat5500

Hello,

I've just noticed high cpu load on our Cat5500, and "show proc cpu" shows that console process is eating up the CPU process.

Does anyone know why is it doing it? Did our Cat5500 go bad??

Thank you for you input in advance.

Dong

____________________

Output of show proc cpu

PU utilization for five seconds: 62.54%

one minute: 13.16%

five minutes: 3.00%

PID Runtime(ms) Invoked uSecs 5Sec 1Min

5Min TTY Process

--- ----------- ---------- -------- ------- -------

------- --- ---------------

1 0 0 0 37.46% 86.84%

97.00% -2 Kernel and Idle

2 1 34 1000 0.00% 0.00%

0.00% -2 Flash MIB Updat

3 1 1 1000 0.00% 0.00%

0.00% -2 runTimeDiag

4 1355 4680 467000 0.00% 0.00%

0.00% -2 SynDiags

5 22162 215022 26000 0.06% 0.00%

0.00% -2 SynConfig

6 17 72898 1000 0.00% 0.00%

0.00% -2 Statuspoll

7 14 10937 1000 0.00% 0.00%

.

.

.

36 206 1313 2000 0.00% 0.00%

0.00% -2 SysLogTask

37 2 1 2000 0.00% 0.00%

0.00% -2 Netflow

38 0 1 0 0.00% 0.00%

0.00% -2 L3Aging

39 33 54456 1000 0.00% 0.00%

0.00% -2 pinggateA

84 88376 12026 383000 62.14% 13.12%

2.00% 0 Console

85 231 1 231000 0.00% 0.00%

0.00% -2 snmpdm

2 REPLIES
Cisco Employee

Re: high cpu load on cat5500

I dont think it is a bad hardware. Is anybody doing any commands on the console session? If so, try stopping it

New Member

Re: high cpu load on cat5500

Hi,

Thanks for your reply.

Actually I was on console session, and only run "show proc cpu". We have couple other ones, but none of other Cat5500 behaved this way.

Thanks again

Dong

77
Views
0
Helpful
2
Replies
CreatePlease login to create content