Router running @ 65%...with Process - IP Input running at 25%...this may be normal operation of the router...any other commands other than "show proc cpu" to determine if router is having memory/cpu problems?
As per Micks' mail ensure that you have the optimal switching paths configured on the box.
If you have secondary-interface addresses consider to configure [ip route-cache same-interface] in order to fast-switch packets received in and routed back-out of the same interface (they are process-switches without his command)
The following commands:
show interface stat
show interface switching
show ip interface
May be useful commands to track down traffic switching paths.
Check also for any related 'known bugs' using bug navigator against your IOS version.
If you have configured optimal switching paths, could also be that the RSP CPU is reaching limits, in which case consider to 'scale' the requirements; perhaps upgrading the RSP, implementing VIP's / distributed-switching or other platform solution....
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...