07-09-2006 07:33 PM - edited 03-03-2019 03:58 AM
Hi All,
When there is a high cpu utilization in Catalyst-6509,in which order it is going to drop the packets ?
In my case when there is a high cpu utilization it is dropping the OSPF packets and adjacencies are getting lost with the neighbors connected to GE module.
What is the Maximum cpu utilization where there is no effect on the system?
Regards,
Madan.
07-14-2006 06:12 AM
check out the following tech note on high CPU utilization on Catalyst 6500/6000 Switch :
http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a00804916e0.shtml
hope this helps.
07-14-2006 06:31 AM
H Madan,
I have experieneced 100% CPU Utilization for a more than a week due to SNMPv3 configuration on 6509 with IOS.
Have you also SNMPv3 enabled?
Regards,
Wilson Samuel
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide