have you tried to turn on cef ? In global configuration mode, type:
Then make sure that none of the interfaces has the command ´no ip route-cache cef´ configured, if that is the case, configure the interfaces with the ´ip route-cache cef´ command. Without CEF, everything is processed switched, which uses a lot of CPU cycles.
You might also ant to check this document:
Troubleshooting High CPU Utilization in IP Input Process
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.