Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Hold-queue command on 4507

I can't seem to find the hold-queue command on Catalyst 4507 {IOS (tm) Catalyst 4000 L3 Switch Software (cat4000-I5S-M), Version 12.1(20)EW2, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)}.

I would like to change output queue from 0/40 to 0/200. Does anyone know the right way to change this output queue?

CHAN4507#sh int fa4/22

FastEthernet4/22 is up, line protocol is up (connected)

Hardware is Fast Ethernet Port, address is 000e.38d9.0e35 (bia 000e.38d9.0e35)

Description: Chantillybkp - 192.168.4.57 - Cabinet#5 - Server Port 28

MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

reliability 255/255, txload 63/255, rxload 6/255

Encapsulation ARPA, loopback not set

Keepalive not set

Full-duplex, 100Mb/s, media type is RJ45

input flow-control is unsupported output flow-control is unsupported

ARP type: ARPA, ARP Timeout 04:00:00

Last input never, output never, output hang never

Last clearing of "show interface" counters 2d06h

Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 687092

Queueing strategy: fifo

Output queue: 0/40 (size/max) ç

5 minute input rate 2505000 bits/sec, 3550 packets/sec

5 minute output rate 24759000 bits/sec, 6023 packets/sec

438585615 packets input, 30983846125 bytes, 0 no buffer

Received 1542 broadcasts (0 multicast)

0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 input packets with dribble condition detected

849088209 packets output, 1012709349205 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out

CHAN4507(config)#int fa4/22

CHAN4507(config-if)#hold-queue ?

% Unrecognized command

Regards,

Santi

2 REPLIES

Re: Hold-queue command on 4507

the 4500 does not support this interface mode command. what are your intentions for trying to adjust the queue?

New Member

Re: Hold-queue command on 4507

Due to output drops are incrementing, I would like to increase output queue from 0/40 to 0/200.

Regards,

Santi

327
Views
4
Helpful
2
Replies
CreatePlease to create content