Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How can I configure no service pad command in CatOS?

hi, i'm a network engineer in japan.

i need a help from you. i wanna configure no service pad command in CatOS.

i can't find any set command in WS-C4003 Software, Version NmpSW: 6.3(2a).

and what's PAD(packet Assembler/Disassembler)??

also, i can't set telnet password in CatOS.

i would appreciate your help.

thanks.

2 REPLIES
VIP Purple

Re: How can I configure no service pad command in CatOS?

Hello,

AFAIK, the service pad only applies to Cisco IOS, and there is no equivalent fo this in CatOS.

As to setting the password for TELNET sessions, set the password first:

set password xxxx

set enablepass xxx

and then define the authentication for the TELNET sessions (depending on what you use, the example below is for TACACS):

set authentication login tacacs enable telnet primary

Regards,

Georg

New Member

Re: How can I configure no service pad command in CatOS?

thank you very much.

i appriciate your help.

1056
Views
3
Helpful
2
Replies