I'm going to install 6513 switch and have a difficulty to connect Ground cable.
I found a small hole in the chassis(below of slot 13 and above of power supply) and I have a ground package shipped with the switch which includes one grounding lug and two M4 screws. no grounding pad shipped
Can anybody guide me how can I connect the ground cable into the 6513 switch ?
As for the grounding pad, look approximately 2" (5cm) to the right of the hole on the front of the chassis. There is a chassis-colored sticker covering the exposed grounding pad. Peel this off and you will find the 2 mounting holes for the grounding lug.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.