Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How can I enter the ? character inside the name of a netbios access-list

I have been trying to configure a netbios access-list using the ? wilcard character inside the netbios name, which is supposed to match any character, and every time I try to do it, I get the help output of the command.

I have been trying to figure out if I need to disable the use of the ? character as the help key, before trying to use the same character inside a netbios access-list.

Does anyone know how to do this? I have been looking inside the CD Documentation, and haven't found anything.

3 REPLIES
Bronze

Re: How can I enter the ? character inside the name of a netbios

The following page gives the syntax you need to be using:

http://www.cisco.com/univercd/cc/td/doc/product/software/ssr83/rpc_r/53999.htm#15724

If you are hitting a brick wall with this, check the bug toolkit for matches.

New Member

Re: How can I enter the ? character inside the name of a netbios

Hi.

Press "CTRL + V" before the "?".

Rgds.

NM

New Member

Re: How can I enter the ? character inside the name of a netbios

Thank you very much for the information.

Regards, Guillermo Kretchmar

156
Views
0
Helpful
3
Replies
CreatePlease to create content