I'm trying to route my data over a carrier network which is using MPLS protocol. My router is connected to a cisco UBR 925 at both ends but i cannot ping through to the LAN at both sides. I'm using a cisco 2600 router.I need assistance in how to actually forward my traffic.
Are you running MPLS on your routers or are you just being a Customer end router ? If running MPLS, please paste in the configs, if not, check if you have proper default or static routing enabled to reach the other end.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...