How can i specify xid for qllc pu1 remote device?

[riccardo_romani]

Hi everyone, please i need to know if putype=1 (no xid sent from remote device) is supported with qllc (IBM SNA over x25) configuration ios 12.1.

If the answer is yes why nothing happen if i specify

qllc xid vmac ..... (the same in switched major node vtam).

Thanks in advance

Riccardo Romani

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.