Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How can i specify xid for qllc pu1 remote device?

Hi everyone, please i need to know if putype=1 (no xid sent from remote device) is supported with qllc (IBM SNA over x25) configuration ios 12.1.

If the answer is yes why nothing happen if i specify

qllc xid vmac ..... (the same in switched major node vtam).

Thanks in advance

Riccardo Romani


Re: How can i specify xid for qllc pu1 remote device?

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center ( or speak with a TAC engineer. You can open a TAC case online at

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.