64000 is 64K for configuring a Frame Relay switch. The difference between 1K = 1000 and 1K = 1024 is in how it is being used. In data storage, due to the way that data is referenced, it is 1024 because it has to be a multiple of two. For data transfer, you are measuring discrete pulses. Since you are measuring discrete pulses, you can use the standard metric value of 1000.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...