Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k

How Could I assign Trunk on 6505 Switch Interface

Hi,

I am Facing a problem about assigning specific interface on 6505 switch as a trunk port that could pass specific tagged vlans, I would like to know how could I configure this interface as layer 2 interface and assign trunk that allows specic tagged vlans.

thanks

2 REPLIES
Silver

Re: How Could I assign Trunk on 6505 Switch Interface

Hi,

Creation of vlan is common for all catalyst 6500 series.

For Creation,

set trunk mod_num/port_num [on | desirable | auto | nonegotiate] negotiate

For assinging specific vlans

set trunk mod_num/port_num vlans

http://www.cisco.com/en/US/products/hw/switches/ps700/products_configuration_guide_chapter09186a00800eb755.html#xtocid99228

Rate if it does,

Rgs,

New Member

Re: How Could I assign Trunk on 6505 Switch Interface

Hi,

If your Catalyst runs IOS, use the following commands :

interface Gix/x

switchport

switchport mode

switchport trunk encapsulation

switchport trunk allowed vlan

Check this URL for more informations: http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a0080160a05.html

Please rate if that helps.

Regards,

Christophe

260
Views
0
Helpful
2
Replies
CreatePlease to create content