Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How do I break into a msfc during boot-up?

After boot-up, Sup mod says that "session 15" is not installed. I need to get into the running-config of the msfc to change the system boot file name. On boot-up, the msfc is trying to boot off a file that no longer exists. So it does not install. I don't care how I get in, I just need to get in!

1 REPLY
Anonymous
N/A

Re: How do I break into a msfc during boot-up?

Reset module 15 in the CatOS and

do a immediate switch console 15.

Now do a send break at the MSFC console. Change the BOOTLDR to the correct settings, save and reset.

The other method of recovery is given below.

Visit the following page on CCO for

the physical layout of the MSFC

http://cio.cisco.com/univercd/cc/td/doc/product/lan/cat6000/cfgnotes/78_6953.htm

Remove the bootflash from the MSFC and boot the switch. This time you should be

able to get into the MSFC by doing a "switch console". You'll see that the MSFC

is in ROMMON. Type the command "set" and see what the bootvariables point to

rommon 2 > set

PS1=rommon ! >

BOOTLDR=bootflash:c6msfc-boot-mz.121-6.E

BOOT=bootflash:c6msfc-jsv-mz.121-6.E,1;

?=1

Now change the bootvariable/Boot loader to nothing and set the Config Register

to 0x0

rommon 2 > BOOT=

rommon 3 > BOOTLDR=

rommon 4 > CONFREG=0x0

Note that the the commands are all upper case. Now type "sync" and then a "reset"

rommon 5 > sync

rommon 6 > reset

System Bootstrap, Version 12.0(3)XE, RELEASE SOFTWARE

Copyright (c) 1998 by cisco Systems, Inc.

Cat6k-MSFC platform with 131072 Kbytes of main memory

Now do a "set" and make sure the changes you have done are there

rommon 1 > set

PS1=rommon ! >

BOOT=

BOOTLDR=

CONFREG=0x0

rommon 2 >

Now put back the bootflash on to your MSFC and boot the switch and hopefully

you should be able to do a "switch console" to get into the MSFC

99
Views
0
Helpful
1
Replies
CreatePlease login to create content