cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
174
Views
0
Helpful
1
Replies

how do i configure a 7206 to use ISDN30 back-up for ATM subinterfaces?

m.tapping
Level 1
Level 1

how do i configure a 7206 to use ISDN30 back-up for ATM subinterfaces? i am running an ATM connected datacentre to which remote FrameRelay sites connect via PVC's. By disconnecting the ATM I am able to get the remote sites to dial-in but unable to route IP traffic over the established circuits, why?

1 Reply 1

ciscomoderator
Community Manager
Community Manager

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: