Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How do I configure Multilink ppp using a VWIC-2MFT-T1

I need to configure a 4 T1 links between two locations and I have 4 VWIC-2MFT-T1 interfaces and 2 3640 routers. I can configure the first or second controller (t1 1/0 or 1/1)by adding ::"channel-group 0 timeslots 1-24 speed 64" , however when I try to add it to the other port on the same card it is not an available option... therefore I cannot configure the Serial interface. How to resolve this ?

1 REPLY
Anonymous
N/A

Re: How do I configure Multilink ppp using a VWIC-2MFT-T1

The capabilities of the T1 interface

are determined by the host it's plugged

into. The 3600 NM-1E2W, NM-1E1R2W, and

NM-2E2W support one serial channel group

per WIC slot only; the NM-1FE2W,

NM-1FE1R2W, NM-2FE2W, and NM-2W support

two serial channel groups per WIC slot.

253
Views
0
Helpful
1
Replies