How do I configure Multilink ppp using a VWIC-2MFT-T1
I need to configure a 4 T1 links between two locations and I have 4 VWIC-2MFT-T1 interfaces and 2 3640 routers. I can configure the first or second controller (t1 1/0 or 1/1)by adding ::"channel-group 0 timeslots 1-24 speed 64" , however when I try to add it to the other port on the same card it is not an available option... therefore I cannot configure the Serial interface. How to resolve this ?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.