Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How do I configure my PIX 506 ver5.1(2) for SNMP

I am trying to configure snmp on my PIX 506 using the commands below without success. Help.

Logged in as enable...

Step 1 Identify the IP address of the SNMP management station with the snmp-server host command.

Pixfirewall#snmp-server host 172.x.x.x

When I do this I get the following message.

Pixfirewall#Type help or '?' for a list of available commands.

Please help.

3 REPLIES
New Member

Re: How do I configure my PIX 506 ver5.1(2) for SNMP

Hi,

A couple of things you're missing. First, you need to be in global config mode(config t), then you need to issue: snmp-server host inside 172.X.X.X

(substitute interface ID depending on where the request comes from..inside, outside, etc)

Lastely, issue: snmp-server community "snmp string"

You should be all set

New Member

Re: How do I configure my PIX 506 ver5.1(2) for SNMP

jcarvalho@ehealthdirect.com, thankyou for your help. That is exactly what I needed to do. Again thank you for your help.

New Member

Re: How do I configure my PIX 506 ver5.1(2) for SNMP

Everything you wanted to know about SNMP and PIX.

http://www.cisco.com/warp/public/110/pixsnmp.html

H/Jorgen

325
Views
0
Helpful
3
Replies