Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How do I filter "all packets" based on MAC-address ?

I want to filter all input packets (IP and non-IP) from a virus PC. Because the user will change his ip address, I have to filter it out by MAC address. This function can be worked in Catalyst 3000 series but I can not find similar feature in Catalyst 3550 series. I had tried applied a named MAC extended ACL in ehternet interface and VLAN map in VLAN interface. Both of them filter out "non-IP" packets only.

1 REPLY

Re: How do I filter "all packets" based on MAC-address ?

Here we go, this should help and get you sorted. Just make sure they are running in L2 mode and not L3

http://www.cisco.com/en/US/partner/products/hw/switches/ps646/products_configuration_guide_chapter09186a00800c6f59.html#xtocid25

88
Views
0
Helpful
1
Replies
CreatePlease login to create content