Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How do I manual set the the port speed on C4k switch?

How do I manually set the speed and duplex setting on the Catalyst 4006 switch. Also is there any way to determine the ip address at the other end of a port(i.e. the origination of the cable coming into my catalyst 4003.) Thanks

1 REPLY
New Member

Re: How do I manual set the the port speed on C4k switch?

SET PORT SPEED mod/port 10/100/auto

SET PORT DUPLEX mod/port full/half

If the other end of the cable is a switch you can enter SHOW CDP NEIGHBORS DETAIL.

If it is a workstation, I may have gone the long route but I set the security to learn one mac address and then looked it up from there.

96
Views
0
Helpful
1
Replies