How do I reload a 831 router back to the factory defaults?
I was running the router#setup utility and when i was done it saved the config.
Then i could not surf so tried to do a write erase on the router# prompt it erased nvram and when it booted back up i had ano startup-config. I did a copy of the running-config to the startup-config and then reloaded the router and it showed a config file but i still could not surf.
I have got the router to accept the ip address of WAN DHCP server but for some reason cannot get it to work on the LAN side. I have tried to specify an ip and subnet on the e0 int but it will not let me surf.
Is there any one that knows how to restore the router back to default out of the box configuration.
Re: How do I reload a 831 router back to the factory defaults?
Thanks. I actually did that but it still did not work. That was one of my issues. I stated that but my issue with that setup the configuration wizard wanted to configure the Lan0 int as the WAN int. When it did i was able to get the wan port ip address DHCP. i think what i need to do is configure the ethernet lan port for ip address pool but i do not know what to name it.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...