Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How do I remove the Serial Interface and Controller T1 entries from the configuration when using a PA-MC-4T1

I cant seem to remove the int se1/2:2 from the config. I have a PA-MC-4T1 card configured for T1 service. Below is what is left in the config.

controller T1 1/2

framing esf

linecode b8zs

channel-group 2 timeslots 1-24

!

controller T1 1/3

framing esf

linecode b8zs

channel-group 3 timeslots 1-24

!

interface Serial1/2:2

bandwidth 1536

no ip address

no ip redirects

no ip unreachables

encapsulation frame-relay IETF

shutdown

no fair-queue

!

interface Serial1/3:3

bandwidth 1536

no ip address

no ip redirects

no ip unreachables

encapsulation frame-relay IETF

frame-relay lmi-type ansi

1 REPLY
Anonymous
N/A

Re: How do I remove the Serial Interface and Controller T1 entri

As long as you have the command

"channel-group 2 timeslots 1-24"

under the controller T1 1/2, that

serial interface will exist. You

can't manually delete it, you would

need to remove/change the channel-

group command.

3308
Views
0
Helpful
1
Replies
CreatePlease to create content