Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

how do I see DS-1 bandwidth utilization on a 1720 serial interface?

How do I see DS-1 bandwith utilization on a 1720 serial int? I don't know which IOS, but it is at least 12.X

1 REPLY
Silver

Re: how do I see DS-1 bandwidth utilization on a 1720 serial int

a sh int serial x will show how much the line is being utilized. the load is calulated by default a five minute average , you can change this nt using the 'load-interval xx' command , In order to calculate the load properly you must change the bandwidth to the size if your pipe. ' bandwidth 64' will change it to a DS0, be careful with this it could efffect routing , Eigrp uses bandwidth for routing metrics.

Serial3/0 is up, line protocol is up

Hardware is M1T-T3+ pa

MTU 4470 bytes, BW 44000 Kbit, DLY 200 usec,

reliability 255/255, txload 5/255, rxload 1/255

Encapsulation HDLC, crc 16, loopback not set

Keepalive set (10 sec)

Restart-Delay is 0 secs

Last input 00:00:00, output 00:00:00, output hang never

Last clearing of "show interface" counters 1d04h

Input queue: 1/75/0/0 (size/max/drops/flushes); Total output drops: 339

Queueing strategy: fifo

Output queue :0/40 (size/max)

30 second input rate 1000 bits/sec, 2 packets/sec

30 second output rate 994000 bits/sec, 128 packets/sec

81324 packets input, 10707022 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 2 giants, 0 throttles

0 parity

1158 input errors, 1107 CRC, 0 frame, 40 overrun, 6 ignored, 11 abort

10542322 packets output, 3862034036 bytes, 0 underruns

0 output errors, 0 applique, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

14 carrier transitions

rxLOS inactive, rxLOF inactive, rxAIS inactive

txAIS inactive, rxRAI inactive,

122
Views
0
Helpful
1
Replies
CreatePlease login to create content