Currently, I am using RTM1.4. I would like to monitor some 3550s' interface utilization. I use the RTM to set some switch templates and apply it to interfaces. Then I show run from the console. I found that the community string in the rmon event is public which is not the community string used in SNMP? What's wrong?
Also, I use RMON to monitor the CPU utilization. The threshold was exceeded and trap was fired. But I don't find the alarm from the RTM Alarm Viewer? What's wrong ?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...