Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How do I show the 'bandwidth' allotment in a 7206VXR?

In a 7206 I am only allowed a certain amount of 'bandwidth' per box, which makes me have to be particular with what modules I can install. Is there a command that will tell me what bandwidth is already used up so I can decide if I can install certain blades?

3 REPLIES
Cisco Employee

Re: How do I show the 'bandwidth' allotment in a 7206VXR?

Bandwidth usage is dynamic. You will have to use a product like concord to poll the interfaces.

Gold

Re: How do I show the 'bandwidth' allotment in a 7206VXR?

Depends on which NPE you have.

for the NPE 200 it depends on the amt of SRAM, figure 3 high speed ints.

(100bm or >)

for NPE 225s

Its on a "points" basis. with 600 points per bus. use full duplex numbers for any interface..i.e 200mb for faste 32 mb for token ring ( I just know you guys still have some).....

The bellevue S.E.s have a doc...I'll try and root it out

Gold

Re: How do I show the 'bandwidth' allotment in a 7206VXR?

I emailed you the doc on 7200 b/w capacity

107
Views
0
Helpful
3
Replies
CreatePlease to create content