Re: How Do I show the CIR on an ATM sub interface connection usi
You can use the show atm vc command on a router to give you the configured parameters or the more specific show atm pvc /. If you have not configured any traffic shaping then the default is UBR and its the port speed. As opposed to Frame-Relay which uses CIR, ATM uses parameters like PCR (peak cell rate), SCR (sustained cell rate) and MBS (Maximum Burst size). See the following url for more details:
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.