06-27-2002 09:30 AM - edited 03-01-2019 11:01 PM
I am trying to use the internet to connect an existing statmux network. The statmux supports frame relay as an output protocol on an RS232 interface.
Statmux--1720--Internet--3640--Statmux
The internet connection is via the ethernet port on DSL routers provided by the carrier.
06-27-2002 09:30 AM
Frame relay cannot be tunneled over IP, but IP can be tunneled over FR.
06-27-2002 12:38 PM
This is an unorthadox application, but this may be worth looking at:
Try looking up this link.
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fwan_c/wcffrely.htm#xtocid44
Both of your routers need to act as frame relay switches. I beleive that feature requires Enterprise Plus code on the router. I'm not sure if the 1720 will do this. I have done it on both 2500 and 2600 routers.
Good Luck;
Doug
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: