I thought I was doing it correctly, by changing the config-reg and then loading the IOS from the bootprompt. When I go back to the normal mode I have the right version IOS, but I lost all my modems and the 8 T1 controllers I have. However they show up in the sh config, but not the running config(Yes I've tried rebooting) also the bootflash hasn't changed. Do I need to change this also. Thanks for the help.
What IOS did you upgrade to ? What does show ver say now? If hope you did not upgrade to 12.0 mainline since you have the octal T1 card which requries T. And so do DMMs which I believe what you might have.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...