Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

How do I verify the power supply status of a Catylst 4000 with 2 power supplies.

I've just had one of the power supplies replaced as it was faulty, however there was no indication in the log that the power supply had been replaced.

The switch is running the following ios:

IOS (tm) L3 Switch/Router Software (CAT4232-IN-M), Version 12.0(7)W5(15d) RELEASE SOFTWARE

The "show environment" command is not supported.

Full "show version" follows:

Cisco Internetwork Operating System Software

IOS (tm) L3 Switch/Router Software (CAT4232-IN-M), Version 12.0(7)W5(15d) RELEASE SOFTWARE

Copyright (c) 1986-2000 by cisco Systems, Inc.

Compiled Mon 05-Jun-00 16:39 by integ

Image text-base: 0x60010928, data-base: 0x605C8000

ROM: System Bootstrap, Version 12.0(7)W5(15b) RELEASE SOFTWARE

ANZAK7-B5 uptime is 2 hours, 12 minutes

System restarted by power-on at 08:54:15 NZST Tue Mar 26 2002

Running default software

cisco Cat4232 (R5000) processor with 57344K/8192K bytes of memory.

R5000 processor, Implementation 35, Revision 2.1

Last reset from power-on

1 FastEthernet/IEEE 802.3 interface(s)

4 Gigabit Ethernet/IEEE 802.3z interface(s)

123K bytes of non-volatile configuration memory.

16384K bytes of Flash internal SIMM (Sector size 256K).

Configuration register is 0x2

1 REPLY
Anonymous
N/A

Re: How do I verify the power supply status of a Catylst 4000 wi

show system will provide that info (look under PS1-Status, PS2-Status)

238
Views
0
Helpful
1
Replies
CreatePlease to create content